← Back to 0-10v integrations
GHL Profilux — Quick Setup
Quick setup guide for connecting your GHL Profilux controller to the aF4 via 1-10v.
Step 1
GHL Profilux — Quick Setup
Image / Video1000 × 1000intro:main
The aF4 requires a 9-10v signal to trigger a feed cycle. In the GHL feeder configuration, set the feeder output level to 9 or higher (shown around the 1:03 mark in the GHL video).
Make sure your GHL Profilux controller is updated to the latest firmware before following these instructions.
Before you begin
This guided wizard is the fastest path to resolution. Completing it routes your request directly to the appropriate technician.
GHL™ has fully integrated the aF4 into their aquarium controller ecosystem. This quick setup walks you through the key requirements; GHL's own knowledge base hosts the detailed step-by-step (with video).
What you'll need
aF4 unit | Powered directly from the wall. |
|---|---|
GHL Profilux controller | Profilux 3, Profilux 4, or Profilux 5 with a free 1-10v output. |
1-10v signal cable | Connecting the GHL 1-10v output to the aF4 link port (3.5mm). |